Manitowoc-ice Q Manuel d'utilisateur télécharger pdf (Page 38)

Maintenance Section 4

4-2

Part Number 000001530

Step 6 Remove parts for cleaning.

A. Remove the splash shield

• Pull forward on left and right nylatch connectors until

disengaged from ice machine (connectors remain

attached to splash shield).

• Remove panel from front of ice machine by lifting

forward and up.

B. Remove the water curtain

• Gently flex the curtain in the center and remove it

from the right side.

• Slide the left pin out.

Water Curtain Removal

C. Remove the ice thickness probe

• Compress the hinge pin on the top of the ice

thickness probe.

Ice Thickness Probe Removal

• Pivot the ice thickness probe to disengage one pin

then the other. The ice thickness probe can be

cleaned at this point without complete removal. If

complete removal is desired, disconnect the ice

thickness control wiring from the control board.

Warning

Disconnect the electric power to the ice machine at

the electric service switch box..

Important

Splash Shield must be reinstalled to prevent water

leakage.

NYLATCH CONNECTORS

PULL FORWARD TO

DISENGAGE

SV1771A

SV3135

COMPRESS

HINGE PIN TO

REMOVE

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Pas de commentaire

Manitowoc-ice Q Manuel d'utilisateur Page 38