Manitowoc-ice S Manuel d'utilisateur télécharger pdf (Page 44)

Maintenance Section 4

4-2

Part Number 000000966

B. Remove the ice thickness probe

• Compress the hinge pin on the top of the ice

thickness probe.

Ice Thickness Probe Removal

• Pivot the ice thickness probe to disengage one pin

then the other. The ice thickness probe can be

cleaned at this point without complete removal. If

complete removal is desired, disconnect the ice

thickness control wiring from the control board.

C. Remove the water distribution tube

NOTE: Distribution tube thumbscrews are retained to

prevent loss. Loosen thumbscrews but do not pull

thumbscrews out of distribution tube.

Water Distribution Tube Removal

• Loosen the two outer screws (do not remove screws

completely they are retained to prevent loss) and pull

forward on the distribution tube to release from slip

joint.

• Disassemble distribution tube by loosening the two

(2) middle thumbscrews and dividing the distribution

tube into two pieces.

SV3135

COMPRESS

HINGE PIN TO

REMOVE

LOOSEN SCREWS

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 59 60

Pas de commentaire

Manitowoc-ice S Manuel d'utilisateur Page 44